Determine width of head rail. Add 1/4" on each end and locate the edge of the box bracket at that location. Screw from the front through the holes to secure the brackets to the wall. There are also holes in the ends and the top for mounting to those locations.
Insert the head rail and snap shut the "door" on the bracket to secure the Blind.
Hold down brackets can be installed if needed for the bottom rail of the blind. Screw the bracket located so the pin will engage in the hole in the bottom rail end cap.
To operate simply rotate the wand to tilt the slats and pull either cord to raise and lower the blind.Lock the cords by pulling to the right and releasing, unlock by pulling to the left and releasing.